Use expanding foam insulation to seal any gaps between the door frame and wall.
Installing trim around sliding glass door.
Threshold molding can be reused on sliding gl.
Place a piece of threshold trim available at the flooring supplier next to patio doors or similar thresholds where you need to stop the laminate flooring.
Measure the lip of the threshold s trim and leave enough clearance between the door and the flooring to install the threshold.
In either case once you re ready to begin choose a side of the door to begin with and start lining the molding up in the exact spots you measured and marked earlier.
Cover the foam insulation with trim and add a small amount of caulk to the visible joint.
Trim with a 1 8 inch gap after the flooring has been laid.
Step 3 install.
Cut all the base extra long rough cut all the baseboards about 2 in.
Make use of various t molds that are available for your laminate here.
If this is the case it is recommended to put the molding up around your sliding glass door piece by piece.
Part of the series.
Nail the cap and shoe.
Secure the threshold to the door with screws.
Use a putty knife to remove the excess.
Make sure the screws aren t exposed.
Nail up the large base photo 13.