Drip edge is an essential part of the roof system.
How to tie gutter into drip edge.
This will prevent water from coming down behind the gutter.
It should extend from the roof decking down into your gutters.
Its main purpose is to eliminate the water from going behind the gutter.
Drip edge is an l shaped piece of metal that is installed at the edge eave of your roof.
With without rain gutters.
The best practice is to always install the drip edge so that it is inside the gutter.
When it rains the water from the roof goes to the edge of the shingles and when the water backflows it hits the drip edge.
If you are installing a roof system drip edges and gutter aprons play the main role.
7 drill 3 16 inch holes into the gutter s front edge using the holes in the brackets as a guide.
If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter.
For proper water drainage the drip edge on the rakes should always overlap the drip edge on the eaves.
Home centers sell rolls of 6 in.
Once the apron s in place fasten it with sheet metal screws.
If not installed properly this will impact the effectiveness of your whole gutter systems.
We can also relate it to gutter systems.
A drip edge or a gutter apron keeps your roof secure by filtering out all the water from the attic into the gutter.
Flashing used to extend drip edge past the fascia.
Push down on the front of the gutter until the back edge of the gutter slides or snaps in.
This works out.
Tools supplies tin sn.
When there is a gap between the gutter and drip edge where water can splash up against the fascia board and run behind the gutter this extension drip is installed behind the drip edge to make water flow into the gutter.
Its purpose is to direct water away from your fascia and rake boards and into your gutters where applicable.
Water stains dirt debris and dripping water behind a gutter are usually the result of poorly installed or missing drip edge.
It should never be installed outside the gutter i e against the fascia board.
The whole purpose is to direct the water into the gutters.
The drip edge further diverts it into the gutter.
