Install the cut tile just as you did the full size tile.
How to glue tile to wood table.
A rolling pin makes a nice tool for this purpose.
I cleaned up the table and then sanded here or there where there were bumps or scratches etc for a smooth finish.
Lift a dollop of grout with a rubber grout float.
Clean excess thinset from the edges of the table.
Coat front and back of the board to ensure it does not absorb any tile adhesive.
Prepare grout powder by mixing it with water until it is the consistency of peanut butter.
Apply a thin coat of tile adhesive to the back of each tile and place it on the mastic.
If the tiles are translucent.
Then i took it outside and gave it one or two quick coats of spray with primer.
Thinset mortar bonds backerboard sheets to the table and it also bonds tile with backerboard.
Place the masonite on the thinset smooth side down and apply a light even pressure over the entire surface.
Using the same thinset mortar that you will use for your tile cover the table top.
Spread a layer of thinset onto the backerboard using a notched trowel.