Installing the roofing felt.
How to flash a roof against a wall.
Metal roof flashing is a galvanized sheet metal bent at right angles with about eight to 12 inches on each side of the angle.
Obviously the further up the wall a flashing extends the greater the resistance to water intrusion.
Metal roof flashing can be use to seal gaps between roof walls.
Next cut from the other corner on the same side of the step flashing and along 45 degrees to the centerfold.
Do not fasten the flashing to the wall because it must float with the roof.
Continuous flashing against a sidewall is one way to install a roof but it s not the correct way.
Likewise a 10 wide flashing will result in a 5 inch wide roof deck flange and a 5 inch vertical flange.
I cut the tape so that it laps onto the housewrap above and 3 in.
Place the first step flashing strip over the end of the starter course shingle and use two nails to fasten the step flashing to the roof with 2 nails.
How to install roof flashing against a wall with a corner lay the underlaymentand the shingles fully up till the wall.
In this video isaac illustrates installation of an 18 w.
Once the flexible flashing is set i apply a piece of housewrap along the wall where the fascia meets it.
It is commonly used in two story and side split houses.
Layer the cement on the area that you.
Step flashing redirects the water back onto the shingle.
Iws is used in conjunction with step flashing or 4x5 wall flashing to create a water tight junction.
The first step flashing or the corner flashing should rest.
A 5 inch wide flashing will result in a 2 1 2 roof deck flange and 2 1 2 vertical wall flange.
For step flashing with a stucco wall you will be working in part on the roof.
Above the roof sheathing.
Flexible flashing tape seals the eave to the wall.
I use a wide piece of flexible flashing tape to protect the area between the subfascia and the wall.
Add cement and flashing.
Next you will use asphalt or roofing cement.
How to install roof flashing against a wall.
